Sanyo ECR-238 - Page 47

Step
Slit mask spring
Selective transmission
gear
Points of Assembly Work
<S side>
Printing wheel
shaft holder shaft holder
!
Frame S Frame T
@ After seting the printing wheel ass’y, rotate the selective gear in the
counter-clockwise direction until it stops.
<POINT IN DISASSEMBLY >
@ To remove R-2, use the jig for removing E-type retaining rings (our
exclusive jig).
@ Attach the ends of the slit mask spring to the slit mask and the hole in
frame T.
Slit mask
Slit mask spring
@ Make sure that the selective gear has been rotated as far as it will go
in the counter-clockwise direction.
@ Align the selective transmission gear’s “ ” mark with the “ ” mark of the
intermittent gear, align the selective transmission gear’s ” “ mark with
the “ “ mark of the selective gear, then press the selective transmission
gear until it clicks into place.
@ If the selective transmission gear cannot be fully seated, rotate it by 90°
by pressing the second reduction gear in the ® arrow direction, then try
pressing the selective transmission gear into place.
< Phase alignment>
Selective gear
Selective
transmission gear