Sanyo ECR-238 - Appendix B. Error Code & Message

Main Assembly D | Motor and Typewheel Ass’y
R-2 (5)
reassembly]
names
of
Parts
|
Points
of
Assembly
Work
1 @ Motor
@ First reduction gear
S-2 (M3 X 3) x2
2 Printing wheel ass’y
x 2
@ Assemble parts @ and ©, the mount them into frame T as follows.
@ With the label on the motor ass’y facing downward, tighten the screws
while pressing the motor ass’y in the § arrow direction.
@ Solder the lead wires from the motor
(see Soldering).
@ Check the phase alignment of the intermittent gear
(see [Main Assembly C],
@ With the slit mask’s frame stopper on top, align the print wheel ass‘y
so that frame T fits between the slit mask and the print wheel shaft holder
and that frame S fits between the selective gear and the print wheel shaft
holder.
@ Set both print wheel shaft holders securely into the frame unit from the
inside, then tighten R-2.
Frame stopper
(should rest on the frame)
erame:. 4 Slit mask
Frame T
~48-