Sanyo ECR-238 - Appendix C. Other problems

Main Assembly E | Timing Detector Ass’y
Reaseomly]
amos
of
Parts
|
Points
of
Assembly
Work
1 Timing signal detector | @ Set the dowel of the timing detector ass’y into the hole in frame T, then
ass'y temporarily tighten S-4.
S-4 (M3 X 18) x 1 | <ADJUSTMENT>
@ Adjust the position of the timing detector ass'y (see section 3.3,
[Adjustment A).
Timing detector ass’y
Frame T
Main Assembly G | Typewheel Guide
ar
Points
of
Assembly
Work
Typewheel guide @ Place the typewheel guide on the dowels on the inside of the frame, then
mount by rotating it in the ® arrow direction around the fulcrum point
of the dowels.
@ Make sure the dowel on the frame S side of the typewheel guide is inside
the hole in frame S.
<POINT IN DISASSEMBLY >
@ To remove the typewheel guide, rotate it in the D arrow direction around
the fulcrum point of the dowels.
Dowel (frame)
¥
Printing wheel guide
Dowel (printing wheel
guide)
<p>
(;
ntermittent gear
—~49-