Sanyo EM-S1000 - 2-Stage Program Confirmation; Verifying Stored Programs

PROGRAM (2-STAGE) COOKING (cont.)
2. Confirmation of Memory
(Example) When program No.3 is programmed as:
First stage (Max power for 30 seconds.) Second stage (Power Level 2 for 10 minutes.)
Operational flow Display Window
1.
2.
4.
Open door
Touch number “3”
Touch “Clear” key
“0” will appear on the display
Stage 1 bar lights. Programmed
No. 3 Input Time 30 sec. (“ .30”)
will appear on the display. After 2
sec., Input Power Level “PL 10”
will appear for 2 sec. and then
return to input time.
Stage 2 bar lights. Programmed
No. 3 Input Time 10 min. (“10.00”)
will appear on the display. After 2
sec., Input Power Level “PL 2” will
appear for in 2 sec. and then
return to input time.
The “0” will appear on the display.
NOTE:
1. Touch “Clear” key after confirming the contents of the units memory.
2. If you wish to change a program memory, touch the “Memory” key twice and then input again as shown in
pages 10 - 14.
13
3.
Touch another “3”