13
Fig.4-15
diode
capacitor
fan holder
screw
capacitor
transformer
H.V.fuse
Fig.4-16
magnetron
diode
Fig.4-17
4
4
.
.
7
7
T
T
H
H
E
E
C
C
A
A
P
P
A
A
C
C
I
I
T
T
O
O
R
R
.
.
Firstly, do as the 1, 2, 3, steps of of this part.
To disassemble,
1. Pull the wires of the capacitor out (4-15).
2. Loosen and take out the screw which fix the capacitor clip
with a “+” – screwdriver, and take out the clip and the
capacitor. (4-15).
To a sse mbl e,
1. Place the capacitor in the capacitor clip with the end which
have three foot near the diode (4-16).
2. Insert one end of the clip in the fan holder trough (FIG.4-15).
3. Tighten the screw, which fix the capacitor clip.
4. Plug in all the plugs of the capacitor.
4
4
.
.
8
8
T
T
H
H
E
E
D
D
I
I
O
O
D
D
E
E
.
.
Firstly, do as the 1, 2, 3, steps of of this part.
To disassemble,
1. Pull out the diode plug, which plugged in the
capacitor.
2. Loosen the screw, which fixed the diode, and
take the diode off.
To a sse mbl e,
1. Insert one end of the diode to one feet of the capacitor’s connect piece.
2. Fix the diode with one screw (pay attention to the polarity of the diode, refer to FIG.4 - 16).
4
4
.
.
9
9
T
T
H
H
E
E
T
T
U
U
R
R
N
N
T
T
A
A
B
B
L
L
E
E
C
C
O
O
M
M
B
B
I
I
N
N
A
A
T
T
I
I
O
O
M
M
.
.
Firstly, do as the 1, 2, 3, stops of of this part.
To disassemble,
1. Turn the microwave oven over (FIG. 4- 17).
2. Take off the two screws which fix the middle base board with a
“+” – screwdriver and take off the middle cover (FIG.4 - 18).
3. Loosen out the two screws of turntable motor with a “+”-
screwdriver, take out the turntable motor and pull out the two
Fig.4-13
screw
fan motor
back board
Fig.4-14
fan
To Next Page
Loading...
