Working Principle of the Unit
1、 ATV PAL signal flow
Receive RF PAL analog signal and sent it to XC5200C (D/A silicon Tuner controlled by main chip
MSD309PX through I
2
C bus) to be demodulated, then differential IF signal is send out to main chip
MSD309PX analog demodulation to be demodulated to get analog CVBS video signal and SIF sound
signal.
CVBS video signal is processed by back-end video decoder, anti-interlacing part, video processor
and zoom controller, then LVDS signal is outputted to drive display panel.
SIF sound signal is processed by back-end demodulator to get analog sound signal, then processed
by pre-amplifier, acoustic effect processor and volume controller. Finally, the sound is sent to earphone
amplifier BH3547F to be amplified and then outputted to earphone jack and an audio amplifier TDA7266SA
to drive speakers.
2、 DVB-T signal flow
Receive RF DVB-T digital signal and sent it to XC5200C (D/A silicon Tuner controlled by main chip
MSD309PX through I
2
C bus) to be processed by down-frequency-conversion, then differential IF signal is
send out to main chip MSD309PX digital demodulation to be demodulated, then standard parallel
transmission flow is outputted to back-end demultiplexer and decoder to be processed.
Video channel: demultiplexing digital video signal is processed by MSD309PX decoder and video
processor, then LVDS signal is outputted to drive display panel;
Audio channel: demultiplexing digital audio signal is processed by MSD309PX decoder and audio
processor, then double-sound-track analog audio signal (stereo) is outputted to MSD309PX to be
processed by preamplifier, acoustic effect processor and volume controller.
3、 AV input signal flow
AV video signal is inputted to main chip MSD309PX to be processed by video decoder,
anti-interlacing part, video processor and zoom controller, then LVDS signal is outputted to drive display
panel;
AV audio signal is processed by voltage divider, resistance matcher and AC coupler, then sent to
main chip MSD309PX to be processed by acoustic effect processor and volume controller.
4、 D-SUB/YPbPr input signal flow
D-SUB、YPbPr video signal is inputted to main chip MSD309PX to be processed by A/D convertor,
video decoder, anti-interlacing part, video processor and zoom controller, then LVDS signal is outputted to
drive display panel;
D-SUB、YPbP audio signal is processed by voltage divider, resistance matcher and AC coupler, then
Finally, the sound is sent to
earphone amplifier BH3547F to be amplified and then outputted to earphone jack and an audio amplifier
TDA7266SA to drive speakers.
Finally, the
sound is sent to earphone amplifier BH3547F to be amplified and then outputted to earphone jack and an
audio amplifier TDA7266SA to drive speakers.
To Next Page
Loading...