Sanyo LED-42XR10FH - Method of Software Upgrading Instructions

Factory software burned instructions listed as Table 7
Table 7 Factory software burned instructions
Model
Loc.
No.
Part No. Part Type
Software
function
Burned
before
SMT
Burning method
N103 5272564002 EN25Q64-104HIP
Main
program
Yes
Use ALL-100 with write-protect,
refer to Note 1 in detail.
N106 5272404002 AT24C04IV-10SU-2.7
HDCP
KEY
Yes Use ALL-100, etc.
N301
N316
5272402002 AT24C02BN10SU-1.8
HDMI
EDID
Yes Use ALL-100, etc.
<26”
CCFL
N305 5272402002 AT24C02BN10SU-1.8
VGA
EDID
Yes Use ALL-100, etc.
N103 5272564002 EN25Q64-104HIP
Main
program
Yes
Use ALL-100 with write-protect,
refer to Note 1 in detail.
N106 5272404002 AT24C04IV-10SU-2.7
HDCP
KEY
Yes Use ALL-100, etc.
N301
N311
5272402002 AT24C02BN10SU-1.8
HDMI
EDID
Yes Use ALL-100, etc.
<26”
LED
N305 5272402002 AT24C02BN10SU-1.8
VGA
EDID
Yes Use ALL-100, etc.
N103 5272564002 EN25Q64-104HIP
Main
program
Yes
Use ALL-100 with write-protect,
refer to Note 1 in detail.
N106 5272404002 AT24C04IV-10SU-2.7
HDCP
KEY
Yes Use ALL-100, etc.
N302
N305
N316
5272402002 AT24C02BN10SU-1.8
HDMI
EDID
Yes Use ALL-100, etc.
≥26”
LED
N309 5272402002 AT24C02BN10SU-1.8
VGA
EDID
Yes Use ALL-100, etc.
Note 1: Method of write-protect setup: enter into burning interface of ALL-100, tick option “Config”,
press item “config Setting”, set option “Protect” as “All Protect”; make sure that option “Config”
must be ticked before burning software and write-protect must be reset after ALL-100 burning
software is opened every time.
Note 2: Method of burning and upgrading software online by using ISP burning device:
a) For main board upgrade: connect 4-pin cable of ISP burning device to Debug port of main board
(<26”: X404, ≥26”: X604); for unit upgrade, connect both D-SUB ports of ISP burning device and
main board, enter into factory menu and set item “Other Settings->ISP Mode” as “ON”;
b) Using Mstar online burning program, enter into menu “Device”, tick option “WP Pin pull to high
during ISP” to ensure that hardware write-protect of Flash is removed and erasing process is
normal, please refer to Fig. 2;
Method of software upgrading instructions