Fig. 5 Option switches
f) Burning process has two steps: Erase and Program; please refer to Fig. 6;
Fig. 6 Option switches
1) First, the step “Erasing…” will last for some time, or it is failed if it is passed by quickly,
please confirm procedure 2）and begin burning process again;
2) Then the following step is “Programming…;
3) A prompt “Pass” will display at last;
g) A prompt “Pass” will display if burning process is successful, please refer to Fig. 7;
Fig. 7 Successful burning process
h) If there are other machines to be burned, remain ISP burning interface and repeat procedures
c）to e）only;
To Next Page
Loading...
