7
INSTALLATION
Installation of MCO-80IC
1. By removing two screws, remove the cover on the
installation location. (Fig. 4)
2. Insert the connector of an enclosed connecting
cable into the location A (Fig. 5) and B, C. (Fig. 6)
A. Connector on the back of the MCO-420MA.
B. Connector CN7 on the main board.
C. Pin TP2 on the main board for 24V power
supply.
3. Fix MCO-420MA to its intended location by using
enclosed four screws. (Fig. 7)
Fig. 7
Cover
Fig. 4
MCO-420MA
Fig. 5
B
Fig. 6
A
MCO-420AM
C
To Next Page
Loading...