Sanyo NS-MQH01U - User Manual

Battery Charger
NC-MQH01U
Operation Instructions
1 Hour/ANAM Charger:
Ni-MH/Ni-Cd Operating Instructions
..
Figure A
ENGLISH
SANYO Canada Inc.
www.sanyocanada.com
Quick Charge positions
1 - 2 AA battery charge
Figure C
1 - 4
AA battery charge
3. Disconnect the charger from the electric outlet once
charging is complete.
4. Remove the batteries from the charger. Batteries may become
warm during charging. Use caution when handling them.
5. The batteries are now ready for use.
-
IMPORTANT SAFETY INSTRUCTIONS
1. SAVE THESE INSTRUCTIONS - This manual contains
important safety and operating instructions for battery
charger NC-MOHOl U.
2. Before using the battery charger, read all instructions and
cautionary markings on the battery charger.
3. CAUTION - To reduce the risk of injury, charge only SANYO
HR-3U and N-3US rechargeable batteries. Other types of
batt~ries may burst causing personal injury and damage.
4. Do not expose charger to rain or snow.
5. Use of an attachment may cause fire, electric shock, or injury
to persons .
6. Do not operate charger if it has received a sharp blow, been
dropped , or otherwise damaged in any way. Have it serviced
at an authorized service center .
7.
Do not disassemble charger. Take it to an authorized service
center for service or repair if required.
8. Incorrect reassembly may result in the risk of electric shock
or fire.
9. To reduce the risk of electric shock, unplug charger from
outlet before attempting any maintenance or cleaning.
Turning off controls will not reduce this risk.
-
Thank you for purchasing this SANYO product.
Please read and understand these instructions carefully for safe and
satisfying operation.
Be sure to keep these instructions handy for future reference.
Features
0 Charger (UL listed)
0 Foldaway plug.
E) Battery type selector switch
(up position for Ni-MH ,
down position for Ni-Cd)
0 4 AA charging positions
0 2 AAA charging positions
0 Battery capacity check position
0 Quick Charge positions
0 LED charge indicator light-
on/off or battery charge capacity
Depending on model,
2 or 4 AA 2300mAH Ni-MH
batteries included
(Charge before initial use) .
•
c®us
USTED9T27
E 153 355 /C LA SS 2
BATTERY C HARGER
BATTERY CAPACITY INDICATOR
How to use check position
1. Slide battery type switch to Ni-MH or Ni-Cd. Place 1 AA or 1 AAA
size battery into the charger's check position so that the +
(positive) and - (negative) ends (terminals) of the batteries
correspond to the same+ and - marking in the charger.
2. The LED charge indicator light will blink red for about 5 seconds.
3. The LED charge indicator light will then display the remaining
capacity of the battery for about 5 seconds before returning to
normal charging mode.
• If the LED charge indicator light displays red- The remaining
capacity of the battery in the check position is 50% or less .
•
If the LED charge indicator light displays orange- The remaining
capacity of the battery in the check position is between 50% and
80%.
• If the LED charge indicator light displays green- The remaining
capacity of the battery in the check position is 80% or more.
..
BATTERY CHARGER: NC-MOH01U
Lt\ WARNING!
• Use to charge SANYO HR-3U, N-3US or N-3U
batteries only.
• Do not immerse in water or use in humid area
such as in a bathroom.
• Insert batteries correctly by matching+ and -
ends of the battery to the same+ and - position
in the charger .
•
Disconnect charger from receptacle (outlet)
before cleaning, maintenance, or when not in
use.
• Be sure to use charger with correct voltage
only (120V AC).
• Do not attempt to charge for more than 2 days
(48 hours) continuously.
• Never handle charger or batteries with wet or
moist hands. Disconnect the plug from the
outlet.
-
0
@
00-
40
OPERATING INSTRUCTIONS
LED CHARGE INDICATOR LIGHT
Light is on (steady) while charging and turns off
automatically when charging is complete.
HOW TO CHARGE
1. Slide battery type switch to Ni-MH or Ni-Cd. Place 1 to 4 of AA
or 1 to 2 of AAA size batteries into the charger so that the +
(positive) and - (negative) ends (terminals) of the
batteries correspond to the same + and - marking in the
charger. For fastest charging time of 1 to 2 AA batteries, insert
them into the Quick Charge positions (Figure A). For charging 1
to 2 AAA batteries, use center positions (Figure B) . NOTICE : AA
and AAA batteries should not be charged simultaneously.
Electrical performances are not guaranteed when AA and AAA
batteries are charged together.
2. Fold out foldaway plug and insert into an electrical outlet of AC
100-240V. The LED charge indicator will be red, and battery
charging begins. (NOTE: Do not insert or remove batteries
during this charging process).When charging is complete , the
cljjlrge indicator light turns off . The charging cycle time
depends on battery type and the condition of the battery . See
chart on the other side.
-
SPECIACATIONS
Sanyo Model No.
_ _NC - MGHOIU
- -
Voltaae AC100 • 240V
---
l_ilQ_ut
-
~ - 60Hz14W
-
ll.!!!Pu _t ____
___Qg . 2V 2.3Almax .I
LED Indication ON steadv - charaina
OFF stand-b o !_ charge complete
Battery / Ni - MH AA 1-2 batteries 60 - 70rnin .
Charge time (2100/2300rnAh) 3-4 batteries 140 - 155rnin.
(minutes)
Ni-MH AA
1 ·2 batteries 60rnin .
approximate (1850rnAh) 3-4 batteries
125rnin .
Ni-MH AA
1 ·2 batteries 52·55min .
(
1600/1700rnAh) 3-4 batteries
105 - llOrnin.
Ni-MH AAA
(750rnAh)
1-2 batteries
65rnin .
Ni-Cd AA
(1000rnAh)
1-4 batteries
100min .
Ni - Cd AA
(700mAh)
1-4 batte rie s 70rnin .
Ni - Cd AAA
(250mAh)
1-2 batterie s
45min .
Dimensions IL x W x H in c hes) 3. 15 " x 4. 72 " x 1. 3""
Wei a ht
approx . 4.75 oz
Manufacturer Charoer Made in China
Batteries Mad e in Japa n
..
• Be sure to charge when the room temperature
is between o·c and 40 "C.
•
Do not insert any objects (such as a
screwdriver
or metal wires) into the charger.
• Do not modify or disassemble.
• Keep out of reach of infants. Children may use
only under strict parental supervision.
• If something appears wrong with the charger
and/or batteries, disconnect from the
receptacle (outlet) immediately and contact the
nearest service center.
Store in a cool, dry place.
~CAUTION! DANGER!
Not following all of the above warnings may cause electric shock,
battery damage/leakage, overheating, explosion, or fire and can
result in severe personal injury and/or damage to property.
-

Sanyo NS-MQH01U Specifications

General

Model	NS-MQH01U
Category	Battery Charger
Compatible Battery Types	AA, AAA
Number of Battery Slots	4
Input Voltage	AC 120V 60Hz
Output Voltage	1.2V DC
Battery Type	NiMH

Summary

Battery Charger Operation and Safety

Charger Features and Components

Details the physical components and built-in features of the Sanyo battery charger.

How to Charge Batteries

Step-by-step guide on inserting batteries and initiating the charging process.

Battery Capacity Check Function

Explains how to use the charger's indicator light to assess battery charge level.

Important Safety Instructions

Crucial safety warnings and precautions for using the battery charger.

Battery Charger Warnings

Critical warnings regarding battery compatibility, handling, and charging procedures.

Battery Usage and Care

Sanyo Battery Usage Warnings

Critical warnings for using Sanyo HR-3U, N-3US, and N-3U batteries.

Charger and Battery Maintenance

Guidelines for cleaning terminals, contacts, and general upkeep.

Additional Battery Information

Notes on battery efficiency variation, temperature effects, and electrical interference.

Additional Charger Information

Notes on charger operating temperature, battery warmth, and electrical noise.

Limited Warranty Information

Sanyo Limited Warranty Details

Explains the warranty coverage, obligations, and exclusions for Sanyo products.