EasyManua.ls Logo

Sanyo TA 4100 - Receiver Section; Transmitter Section; Microphone Specifications

Sanyo TA 4100
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SPECIFICATIONS
CIRCUIT TYPE: Transistorized, dual conversion superheterodyne with two
ceramic IF filters. Crystal controlled synthesized channel
frequencies using the Phase Lock Loop system.
RECEIVER SECTION
Frequency Coverage
18 channels
27.015 to 27.225 MHz
Sensitivity
0 5,uV for 10 dB S+N/N
Selectivity
±3 kHz at —6 dB
Adjacent Channel Rejection
55 dB
Audio Distortion at 1000 Hz
Less than 10% at 4 watts output
I F
1st
9.785 MHz
2nd
455 kHz
Squelch
Adjustable from 0.25 ,uV
TRANSMITTER SECTION
Frequency Coverage
18 channels
27.015 to 27.225 MHz
Power Output
4 watts maximum
Modulation
Will not-exceed 100%
Spurious Radiation
60 dB down or better
Emission
6A3
Frequency Tolerance
0 005%
Antenna Impedance
50 ohms
Current Drain (13.8 volts DC)
250-1600 mA (from no signal
receive to full modulation on
transmit)
MICROPHONE SPECIFICATIONS
Type — Dynamic (Standard)
Impedance — 500 ohms
Switching — Electronic
System — 4 wires