Sanyo VA-80EX User Manual

About this manual
This housing is designed for outdoor installation.
Before installing and using this unit, please read this manual carefully. Be sure to keep it handy for later reference.
CAUTION:
Install this housing securely according to this
installation manual. Be aware that allowing the bracket
to fall with the camera on it may cause personal injury.
b Specifications
Color: Beige
Material: Metal
Waterproof Standard: Conforming to IP66
Operating Environment
(with power source connected) :
Temperature; -30°C - +50°C (-22°F - +122°F)
Humidity; less than 90% RH (no condensation)
Weight: Approx. 2.5 kg (5.5 lb)
Dimensions:
b Specifications of Heater
(built into VA-CM8C/CM8S)
Automatic switch ON/OFF temperature:
ON; Approx. 5°C (41°F)
OFF; Approx. 15°C (59°F)
Power supply: 24 V AC ± 10%, 50/60Hz
Power consumption: Max. 35 W (When heater turned on)
Example of
wall mounting
Example of
pendant mounting
Important
• Be careful when opening holes for installing the
unit. Work with the power and video cables pulled
out for easy installation.
• Make sure to properly perform waterproofing for the
ceiling or wall where you are installing the unit.
• Make sure that the surface in the installation
location has no unevenness and is strong enough
to bear the total weight of the unit.
Ǿ248 (9.8)
182 (7.2)
6 (0.2)
Unit: mm (inch)
INSTRUCTION MANUAL
Outdoor Housing
VA-80EX
Features and specifications are subject to change without
prior notice or obligations.
Accessories
Waterproof tape
Hexagonal wrench
Screws, washers
(for power board unit)
This installation should be made by a qualified service
person and should conform to all local codes.
EnglishFrançaisEspañolDeutsch中文简体日本語
L9BHK_WA(VA-80EX).book 0 ページ ２００７年１月１２日 金曜日 午後３時３５分

Sanyo VA-80EX Specifications

General

Output Current	1.5A
Connector Type	Proprietary
Type	AC Adapter
Power Source	AC
Input Voltage	100-240V

Summary

About the Outdoor Housing Manual

Installation Safety Caution

Warning about securing the housing to prevent personal injury from falling parts during installation.

Key Installation Guidelines

Important steps for unit installation including cable management, waterproofing, and surface integrity.

Product Specifications Overview

General Unit Specifications

Details on color, material, waterproof rating, operating environment, weight, and dimensions.

Heater Module Specifications

Information on the heater's automatic switch temperatures, power supply, and consumption.

Critical Safety Precautions

Electrical Shock Prevention

Caution against opening the product, touching cables with wet hands, or inserting foreign objects.

Fire and Moisture Hazard Warnings

Warning to avoid exposing the product to rain, moisture, or water to prevent fire or electric shock.

Installation Stability and Vibration

Advice against installing on unsteady surfaces or in places subject to vibration to prevent falls or damage.

Regulatory Compliance Information

Details on FCC compliance for Class B digital devices and measures to correct radio interference.

Outdoor Housing Assembly Steps

Attaching the Dome Cover

Procedure for attaching the dome cover, including connecting the safety wire and fan/heater cables.

Mounting the Power Board Unit

Steps for installing the power board unit, securing it with screws and aligning orientation.

Connecting Cables

Instructions for connecting the 24V AC power cable and other cables to the power board unit.

Mounting the Camera Unit

Procedure for mounting the camera unit to the housing, including safety wire, alignment, and cover removal.