The setting values are interlocked among RECORDING, E-MAIL SETTINGS, and FTP SETTINGS
screens. (Note that the setting configured most recently will take precedence.)
B If you selected “ALARM IN1/2”, “MOTION”, or “ALARM OUT1/2” ...
In [DURATION], select the image transmission duration.
5SEC, 10SEC, 20SEC, 40SEC, 1MIN, 2MIN, 3MIN, 4MIN, 5MIN, 10MIN, 15MIN
C If you selected “INTERVAL”, “ALARM IN1/2”, “MOTION”, or “ALARM OUT1/2” ...
In [INTERVAL], select the interval between e-mail transmissions.
1SEC, 2SEC, 3SEC, 5SEC, 10SEC, 30SEC, 1MIN, 3MIN, 5MIN, 10MIN, 15MIN, 30MIN, 1HOUR, 2HOUR,
3HOUR, 4HOUR, 5HOUR, 6HOUR, 8HOUR, 12HOUR, 24HOUR
The interval options available when you selected “ALARM IN1/2”, “MOTION”, or “ALARM OUT1/2” in
[TRIGGER] are only “1SEC” to “15MIN”.
In [INTERVAL], the pull-down menu will only show options that do not exceed the [DURATION]
setting.
2 In [JPEG IMAGE], select the JPEG stream you want to send and click SET .
You can send JPEG images only.
You need to configure the video conditions for each stream on the VIDEO & AUDIO SETTINGS
screen.
The pull-down menu shows a list of streams for which you selected “JPEG” in [CODEC] on the
VIDEO & AUDIO SETTINGS screen.
A warning message will appear if there is no JPEG stream available.
To Next Page
Loading...
