After installing an SD memory card into the camera, you need to configure the alarm recording settings as
described below.
You can store the following data on an SD memory card. However, you cannot use SD memory
cards to record normal surveillance video that is not alarm video.
Alarm video recording
Backup video recording in event of a network failure
Access and system logs
1 Click SD in the configuration menu.
On the SD MEMORY CARD screen, format the SD memory card as required.
Setting Item Default Setting Required Setting/Operation
1 SD MEMORY
CARD
NO USE USE (Records data onto SD memory card.)
2 AREA ALARM (Alarm/backup recording storage
area): 100
LOG (Log information storage area): 0
To secure a log information storage area, change the
[LOG] value.
3 SIZE/FORMAT Displays the storage capacity of SD
memory card
Check the storage capacity and click FORMAT .
When finished formatting the SD memory card, close the SD MEMORY CARD screen.
2 Click RECORDING in the configuration menu.
On the RECORDING screen, configure the recording settings as follows.
Setting Item Default Setting Required Setting
1 RECORD STREAM OFF Select the desired stream (STREAM1 to
STREAM4).
2 ALARM EVENT1 OFF ON
You can configure three patterns of recording
conditions (for ALARM EVENT1 to 3).
3 TRIGGER (Recording
trigger conditions)
ALARM IN1 (Triggers recording when
ALARM IN1 terminal receives an alarm
signal.)
ALARM IN2, MOTION, ALARM OUT1/2,
NETWORK FAILURE
4 PRE ALARM OFF ON (Records video for a specific period
before alarm occurrence.)
When finished configuring the above basic recording settings, configure the recording schedule as required.
Quick O
To Next Page
Loading...
