Sanyo VDC-HD3500P - Page 67

The RTSP port number must be 554 or otherwise a number in the range of 1 to 65535.
The RTP port (video and audio) numbers must be even numbers in the range of 1026 to 65534
(except for numbers between 3874 and 5000, between 9874 and 10000, between 38087 and 38214,
and between 49026 and 49152).
If you intend to access the camera from video viewer or similar software, you may name each stream (access
name) as you like for easy identification.
1 Under [ACCESS NAME (JPEG)], type an access name for each JPEG stream and click
SET .
These settings are used for each stream for which you set the codec to “JPEG” on the VIDEO & AUDIO
SETTINGS screen.
An access name must be specified for each stream (up to 32 alphanumeric characters).
2 Under [ACCESS NAME (H.264)], type an access name for each H.264 stream and click
SET .
These settings are used for each stream for which you set the codec to “H.264” on the VIDEO & AUDIO
SETTINGS screen.
An access name must be specified for each stream (up to 32 alphanumeric characters).
To enable multicast streaming, configure the multicast address, port numbers, and TTL settings for each stream
and click SET .
W
orkin
g
with Administrator Confi
g
uration Screens 6
/
66