1 Select the [MANUAL] check box.
Now you can operate the NEAR , FAR , and ONE PUSH buttons.
2 Click ONE PUSH to focus on the subject.
The camera automatically focuses on the subject. Note that the color of the status indicator ( A ) “FOCUSING”
turns from black to orange.
If the camera fails to focus on the subject, the status indicator ( A ) will show “ERROR”. In this case, manually
adjust the focus (in Step 3 ).
3 Click NEAR / FAR to focus on the subject.
4 Deselect the [MANUAL] check box.
Be sure to deselect the check box to prevent the loss of focus due to wrong operation.
The check box is automatically deselected if you switch from the focus adjustment screen to another
screen.
Use the mirror function to electronically flip the displayed subject.
If you installed the camera upside down or intend to monitor the subject in the mirror, configure the following
settings according to the installation environment of the camera.
In [MIRROR], select the desired mirror mode and click SET .
OFF:
Disables the mirror mode (normal video).
HV:
Flips the video vertically and horizontally.
H:
Flips the video horizontally.
V: Flips the video vertically.
To Next Page
Loading...
