Sanyo Vizon DP32746 - Component Board Removal Procedures

— 8 —
1: DIGITAL BOARD REMOVAL
1-1. Remove the tuner nuts from the analog and digital
tuners and remove earth plate connecting the
tuners.
1-2. Remove 4 screws (3X6) to take off the digital board.
2: MAIN BOARD REMOVAL
2-1. Remove the tuner nuts from the analog and digital
tuners and remove earth plate connecting the
tuners.
2-2. Remove 9 screws (3X6) to take off the main board.
3: POWER BOARD REMOVAL
3-1. Remove 6 screws (3X6) to take off the power board.
4: CONTROL BOARD REMOVAL
4-1. Remove 2 screws (4X14–special screw) to take off
the control board.
5: SPEAKER REMOVAL
5-1. Remove 4 screws (4X14–special screw) to take off
the speaker.
6: STAND BASE REMOVAL
6-1. Remove 5 screws to take off the stand base.
4X14–special screw 3 pcs
3X6 2 pcs.
LCD PANEL REMOVAL
1: STAND BASE REMOVAL
1-1. Remove 5 screws to take off the stand base.
See above.
2: LCD PANEL REMOVAL
2-1. Disconnect the lead wires from the LCD panel,
speakers, and control board.
2-2. Remove 4 screws (4X14–special screw) and take
off the mounting frames with the chassis plate,
power board, main board, and digital board.
2-3. Lift the LCD panel from the front cabinet.
5
5
1
2
3
4
6
Earth Plate
LCD Panel
Main
Digital
Chassis Plate
Mounting Frame Mounting Frame
Power
MECHANICAL DISASSEMBLY (CONT.)