Sanyo VM-D6P - CAMERA RECORDING

CAMERA RECORDING
REC button
1, Set the FOCUS switch to the AUTO position.
Focus is automatically adjusted.
2. Set the WHITE BALANCE switch to the AUTO position.
White balance is automatically adjusted.
3. Setthe REC MODE/EDIT switch to the SP or LP position.
4. Switch the power on.
The POWER lamp will light.
5. Slide the EJECT switch.
6. Insert a cassette. Gently press the cassette holder
("PUSH” indicator section).
The unit will enter the recording pause mode.
7. 8) Press the REC START/STOP button once. The REC/
PAUSE lamp will stop blinking, remain on, and
recording will begin.
b) Press the REC START/STOP button a second time.
The REC PAUSE mode will begin, and the REC/
PAUSE lamp will blink.
c) Repeat steps a) and b) to continue recording.
d) After recording, eject the cassette and switch off the
power.
Recording from the STOP mode
a) To begin recording from stop mode, press the REC
button, to enter the recording pause mode.
Then press the REC START/STOP button.
b) Press the REC START/STOP button or STOP button to
stop recording.
Notes :
if you pause in the Hecord mode for more then say 90
seconds, it is recommended to switch off the camcorder to
conserve the battery.
NONMINAL DISCHARGE TIMES
NP-55 45mins
NP-77 90mins
These times will be variable due to the type of use, ie: if the
Zoom is used frequently, or the Focus range and Light level
changes often, each of these will Therefore we recommend
that a spare battery be carried to avoid dissapointment at
a crucial moment when recording.
Notes :
This is not an indication of a malfunction.
. @a) Battery power operation: e
"ze Vertical stripes may appear if recording is attempted under candle light or in other conditions where the light is dim.
lf the recording pause mode continues for about 5 minutes, the power will be switched off automatically.
After about 5 minutes in the stop mode, the power will be switched off automatically.
. b). AC power operation : If the recording pause mode continues for about S minutes, the unit will enter the stop mode.
@When fluorescent lamps or mercury-vapor lamps are used for lighting, the recorded images will. flicker.