Condensation
Condensation is the moisture that forms on the
outside of a glass when you fill it with cold water.
The first sign of condensation is fogging of the
camcorder lens and viewfinder.
To stop the formation of condensation, wrap the
camcorder in a cloth until the fogging on the lens
and in the viewfinder disappears.
Do not use the camcorder before condensation has
disappeared as that may cause damage to the video
heads.
Conditions
where condensation might appear
n
If the camcorder is suddenly moved from a cold
place to a warm, humid one, or vice versa.
n
If a heater has been turned on to quickly heat
the room, or if the level of humidity is high.
n
If taken from an air conditioned room, or car to
a hot, humid place.
Condensation warning indicator
If condensation is detected inside the camcorder,
the condensation warning indicator will flash in the
Viewfinder. (See page 5.)
n
As condensation may also appear inside the
cassette casing, the cassette warning indicator
might also flash when the cassette is loaded.
Do not load a cassette in the camcorder if you
suspect that condensation has formed inside the
cassette.
If condensation has formed
Eject the cassette and wait for 1 - 2 hours for the
condensation to dry.
The time required to completely eliminate
condensation may vary.
WARNING:
UNAUTHORIZED RECORDING OR USE OF
TELEVISION PROGRAMMING, BROADCASTS,
VIDEO TAPE, FILM OR OTHER COPYRIGHTED
MATERIAL MAY VIOLATE APPLICABLE
COPYRIGHT LAWS. SANYO ASSUMES NO
RESPONSIBILITY FOR UNAUTHORIZED
DUPLICATION, USE OR OTHER ACTS WHICH
INFRINGE UPON THE RIGHTS OF COPYRIGHT
OWNERS.
4 English
To Next Page
Loading...
Need help?
General
