About the camcorder
A.
Power zoom lever (X16)
Press on the T side for a close up
a shot (zoom-in)
and
on the W side for a wide angle shot
(zoom-out). The zoom setting will be indicated,
in
the viewfinder, by the position of the (w) symbol.
The (M) symbol will move according to the pressure
on the power zoom lever. The zoom setting display
will be cancelled about 3 seconds after the power
zoom lever is released.
l
When the POWER/CHARGE switch is turned
off, the zoom will automatically return to the
zoom-out position.
B.
Remote
control sensor
The remote control can be used within a range of 4
m
(13
ft) from the front of the sensor.
C.
Microphone
D.
Shoulder belt hook
Use
a commercially available shoulder belt.
E.
Lithium battery tray
Insert the lithium battery in the tray with the (+)
sign facing up.
After the lithium battery is installed, the time and
date will need to be set. (See page
13.)
F.
Eyesight compensation ring
Turn the camcorder on, then while looking into the
viewfinder turn the ring, to the right or to the left,
to obtain the clearest possible picture.
G. Video/Audio terminals
@ Video output terminal (VIDEO)
Q DC output terminal
(for RF converter)
@
Audio output terminals
(AUDIO)
The VM-EX41 OP is monaural.
n
Tripod screw mount
Located under the unit.
H.
Viewfinder displays
q
Warning indicators (blinking)
TAPE : The tape is within about 5 minutes from
the end.
TAPE END: The tape has reached the end.
&@
:
The erasure-prevention switch on the
cassette is set to the
red position
(See page 11).
: No cassette is loaded.
:
Condensation has formed inside the unit
or the cassette.
g
:
Condensation has formed inside the unit
or the cassette.
In the following conditions the warning
beep, will
sound 10 times. (For
more details, please refer to
page 15.)
TAPE
END: If the tape reaches the end while
recording, or if trying to record when the
tape is at
the end.
m, m:
If trying to record in these conditions.
English
5
I
To Next Page
Loading...
