Sanyo XT-43S7200F - Basic Connection; Power Connection and Aerial

Introduction
6
1 AC IN ~
2 AV OUT
3 AV1 IN
4 AV2 IN/PC AUDIO IN
5 PC
(P.8)
(P.8)
(See below)
(P.7)
(P.8)
(P.8)
(P.7)
(See below)
(P.7)
6 HEADPHONE
7 USBX2
8 ANTENNA
9 HDMIX3
1 2 3 4 5
6
7
8
9
Basic Connection
Terminals
Power connection and aerial
ANTENNA cable
AC cord
110 – 240 V ~
50/60 Hz
Note
TV
Aerial
Power Connection
Connect the TV’s power cable to a power outlet.
Do not place the RF cable under the TV.
To obtain optimum quality picture and sound, an aerial, the correct cable(75Ω coaxial), and the correct terminating
plug are required.
If a communal aerial system is used, you may require the correct connection cable and plug between the wall aerial
socket and the TV.
Your Sanyo Service Centre or dealer may be able to assist you in obtaining the correct aerial system for
your particular area and the accessories required.
Any matters regarding aerial installation, upgrading of existing systems or accessories required, and the costs
incurred, are the responsibility of you, the Customer.
PC
AV2 IN
(PC AUDI O IN)
AV OUT
AC IN~
L
AV1 IN
VID EO
R
AUD IO
HDM I 3
HDM I 2
(SOU ND OUT)
HDM I 1
ANT ENNA HEA DPHON E
USB 2 .0
USB 2 .0