39
Saratoga Spa
®
OWNER'S MANUAL
OPERATING THE HYDRO PUMPS
Jets 1 Button
Activates the hydro jet pump #1 for maximum hydrotherapy jet action. Press the Jets 1
button once for low speed, again for high speed and again to turn the pump off. When the
pump is activated the indicator above the Jets 1 button will light up. The pump will turn off
automatically after 15 minutes on high speed and 4 hours on low speed.
Jets 2 Button
Activates the hydro jet pump #2 for maximum hydrotherapy jet action. Press the Jets 2 button
once for high speed and again to turn the pump off. When the pump is activated the indicator
above the Jets 2 button will light up. The pump will turn off automatically after 15 minutes on
high speed.
Jets 3 Button
(Empire, Lincoln, and Broadway XL Models Only)
Activates the hydro jet pump #3 for maximum hydrotherapy jet action. Press the Jets 3 button
once for high speed and again to turn the pump off. When the pump is activated the indicator
above the Jets 3 button will light up. The pump will turn off automatically after 15 minutes on
high speed.
Note: The spa light will begin flashing 15 seconds before the pumps shut off as a reminder, that
the pump(s) cycle is about to end.
Note: The Adelphi model only has 1 jet button on the panel.
Note: Saratoga Spas® models are designed for maximum heat retention. The unit is
not designed to cool water. If the set or desired temperature is below that of the ambient
temperature, the unit will not be able to achieve this demand. Depending on the desired
temperature, it may be necessary to add cool water to the unit to lower your spas water
temperature.
To Next Page
Loading...