● INSTRUCTION MANUAL FOR INSTALLATION AND USE
● GEBRAUCHS- UND BEDIENUNGSANLEITUNG
● MANUEL D'INSTRUCTION POUR L'INSTALLATION ET L'USAGE
● MANUALE PER INSTALLAZIONE E USO
Wurstel warmer
Wurstwärmer
Chauffe-saucisses
Scalda wurstel
MODEL. CS 100
Best.-Nr. 172-1060
UK F I D
●
General Instructions
Read carefully the instructions given in this booklet. Before connecting the appliance make sure that the data shown
on the technical plate (fig.2), corresponds with that of the mains power supply. Before carrying out any operation,
insulate the appliance from the mains power supply. The installation must he carried out by professionally trained
personnel in accordance with the instructions of the manufacturer and current regulations. The Manufacturer declines
all responsability for:
−
Any damage resulting from ignoring the instructions for installation and use or from irregular use of the appliance.
−
Any inaccuracies contained in this booklet due to copying or printing errors.
The Manufacturer reserves the right to make alterations thought useful to the product, without changing its basic
characteristincs.
●
Technical data
●
Installation instructions
1. The identifying and technical plate is fixed to the back of the appliance (fig.2).
2. Remove the protective film.
3. ELECTRICAL SAFETY RULES:
Please observe these essential rules:
− the mains voltage and that on the technical plate must be the same;
− connection must be to a REGULATION earthed socket;
− connection must be to an equipotential system;
The electrical connection must be carried out by trained personnel in accordance with electrical norms.
The power cable must be positioned so that no part of it reaches a temperature by 50°C. Before
installation make sure that the socket or switch used can be easily reached when the apliance is in
place.
CAUTION
: PRODUCER DECLINE ALL RFSPONSABILITY IF THESE SAFETY RULES ARE NOT OBSERVED.
● Instruction for use
1. The appliance is intended for collective use and must be used by properly trained personnel.
2. Before switching on the machine for the first time, thoroughly clean off the industrial oils.
3. Before switching on the machine, pour water into the wurstels conteiner
.
● Starting up
1. Put the plug into the power socket.
2. Turn the thermostat (A fig.1) until the temperature setting required is reached. The heating light (B
fig.1) will come on and will go off when the set teparture is reached.
3. Now the appliance is ready to be used.
UK
CS 100
Dimensions en mm
280 x 260 x 420H
Puissance
1000 W
Branchement
230 V 1N
To Next Page
Need help?
General