18 EVO1Y | LAB1Y Operating Instructions
Installation
t Insert the power plug adapter into the power supply. The grooved button must
be facing upwards.
t Push the power plug adapter as far as you can until it clicks into place.
t Check whether the power plug adapter is securely locked in place by pulling it
gently.
y If the power plug adapter does not move, it is locked in place.
Removing/Replacing the Mains Adapter
t Press the grooved button from above and pull back on the mains adapter.
t Push the power plug adapter out of the power supply and remove it.
Power Connection/Safety Precautions
− Only use original Sartorius AC adapters.
The AC adapter has an IP rating of IP40 in accordance with EN60529 / IEC60529.
− Make sure that the voltage rating printed on this unit matches the voltage at the
place of installation.
− If the stated supply voltage or the plug design of the AC adapter does not comply
with your country's standard, please inform your nearest Sartorius representative.
− The power must be connected in accordance with the regulations applicable in
your country.
To Next Page
Loading...
