Setting Up the Scale
– QC 7 Models:
Carefully unpack the scale and accessories.
Mounting the Display Unit on a Table or Wall
(optional; order no. YDH01TS)
– Remove the retainers (5) from the support arm
– Remove the display unit
– Unfasten the screws on the display unit (7) and
remove the retainers.
– Slide the clips (6) which hold down the cable in
the raceway (channel) up and out of the support arm;
then remove the cable from the raceway.
– Remove the support arm.
– Then slide the clips back onto the support arm.
– Fasten the display unit holder to the display unit
using the retainers (5)
1–10
To Next Page
Loading...
