Data ID Codes
To help you identify weights, piece counts, percentages, etc., a code letter is
printed or displayed in front of these values.
If you set the code for “without data ID code,” only net weights, results in percent
and counting results will be output. You will find the data ID codes for a particular
application program listed in the corresponding description. The ID code
increases the data output format for each weight readout from16 to 22 characters.
ID code for data output Code Changes
Without 7 2 1
With 7 2 2 *
Automatic Output of the Tare Memory Data
If you have assigned the o/t key (22) to the tare memory, the following
values will be output automatically:
Code Changes
Last net value (individual value N1) 7 3 1 *
Tare memory data (tare balancing memory) 7 3 2
This function only works in conjunction with the code setting 7 1 2 – “Automatic
Output of the Application Parameters.”
* = factory setting
2–11
To Next Page
Loading...
