Simple Counting
The QC counting program is set at the factory so that you can begin counting
without changing any settings.
If you want to change the factory-set reference sample quantity, press
g/W (13) to select one of the settings (5,10, 20, 50,100 or user-definable
quantity –- this latter setting has been factory-set to 999*.
Place a container on the scale, press the =/z key (14) to tare or use the
“tare memory” application.
Start the automatic container taring function by pressing the S/a key (see the
section on “Tare Memory”).
Count the corresponding number (e.g.,10 parts) into the container.
Press the u/w key (12) to start counting. If you add any number of parts to the
container, the current piece count in pcs will be displayed.
Important Note:
If –UPD–- is displayed, the scale will automatically recalculate the average piece
weight, used as a reference, from the piece count and weight on the scale and you
will hear a beep.
With the menu setting 7 1 2, the average piece weight (reference weight) and
the reference sample quantity are output to an on-line printer after the last positions
in the weight display have stabilized. If the reference weight has not been
entered manually, the data output is generated after the reference weight has been
calculated with up to 3 additional digits after the decimal point, depending on the
scale type. If the reference weight was entered manually, the data output
generated has the same number of digits as the value entered.
* = user-definable piece count
3–6
To Next Page
Loading...
