Sartorius QC7DCE-S - Checking Net Weights

Checking Net Weights
Checking net weights z/T key, user guide
display shows: Set, S–, S+ Code 2 6 2*
Practical Example: Check weight Symbol displayed: +/–
Application: Checking the weight of bulk parts of identical weight;
e.g. checking packages of screws where the packages have the
same weight, checking the fill quantity, sorting.
Use the numeric keys 0 – 9 to enter values.
Menu codes used in the example:
Function Code
Output over/
under checkweighing: on 4 2 1
Output all parameters 7 1 2
Step/Key Display Data Output
Press the =/z key
0.0 g
Place a closed package
of screws on the scale +
100.1 g
Press the z/T key + 100.1 g
The tolerance limit symbol
flashes; the user guide
display shows
SEt = target weight
Press the z/T key to store
the weight value + 100.1 g
The user guide display shows
S– – = min. weight + 100.1 g
Enter the tolerance
values (e.g.1g) using the
numeric keys 1 . 0 g
1.0 g
Press the z/T key again + 100.1 g
the user guide display shows
S–t = d–max. weight + 100.1 g
* = factory setting
3–24