8
Plug & Play Mode with Autoprint (SBI)
To use the autoprint function, you need to deactivate
the plug & play mode. This setting is configured in the
same dialog as that described above for changing the port
number.
Using Different USB Ports on a Single PC
Driver installation must be performed each time the cable
is connected to a different USB port. It is a good idea to
use the same port every time, if possible.
Deinstalling the Driver
– Select “Start"
“Settings" “Control Panel"
– Select “Software"
– Select “FTD1USB Serial Converter Driver"
– Click on “Add/Remove"
> The software is deinstalled.
To Next Page
Loading...