Cleaning and Maintenance
The pre-lter cartridge lter can be cleaned from the outside of the vacuum by utilizing the manual purge
lever. To use the manual lter purge system, rst you must block or close the air hose inlet, then repeatedly
pull the manual purge handle. This operation will produce sudden bursts of air to the lter. This mechanical
cleaning process will eject dust from the surface of the lter thus allowing a more efcient cleaning
operation. This should be done often during the grinding process. The HEPA lters should be taken out and
cleaned on a daily basis.
Manual Purge
Hose
Handle
HEPA Filter
Vacuum Gauge
Carbon Brush Motors
Rear Wheel
Upper Top Lid
Upper Lid for Bin
Anti static Filter Cartridge
Canister
Air Intake
Bagging Foundation
Front Wheel
Elongated Bags
1st Stage Cartridge Filter 2nd Stage HEPA Filter
Product Parts Diagram
To Next Page
