To stop scarifying, lift the black handle up and proceed in a backward motion until the
lever is in the uppermost position
Changing the cutter drum:
Always be sure to switch off the machine before removing the endplate. This will prevent
any flying debris from injuring the worker. Remove the cover nuts from the endplate, and
then remove the endplate to expose the cutter drum assembly.
Dust Control:
Should dust control be of concern, please contact SASE Company, Inc. to inquire about our
powerful dust control vacuums. The SC12E can be used with an optional 2” vacuum
connection.
If you need further assistance, please call our toll free number 1-800-522-2606.
SASE Company, Inc © 2006 All Rights Reserved
To Next Page
Loading...