EasyManua.ls Logo

Sase SC8E - Poisonous Exhaust

Default Icon
50 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SASE Company, Inc. Scarifier SC8E User Manual
____________________________________________________________________________________________________
8
Switch motor OFF before disconnecting power.
Do not disconnect power by pulling cord. To disconnect, grasp the plug, not the cord.
Unplug power cord at the machine when not in use and before servicing.
Starting the Engine/Motor for Electric Models
Be sure the “OFF” button is depressed on the motor starter box.
Hook up the correct voltage/phase electrical power source by plugging into the connector provided. If the cord
does not mate with the connector, consult a qualified licensed electrician before continuing.
Verify that the electrical current being supplied is the proper voltage and phase required to run the equipment.
POISONOUS EXHAUST
Gasoline Powered Models
DO NOT operate any gasoline powered equipment without adequate ventilation. Carbon monoxide is an
invisible, odorless gas that can kill.
NEVER REFUEL A HOT ENGINE OR AN ENGINE WHILE IT IS RUNNING.
Only refuel a cool “stopped” engine in a well-ventilated area. Properly clean any spilled fuel before starting the
engine.
Gasoline is extremely flammable and poisonous. It should only be dispensed in well ventilated
areas, and with a cool engine..
Engine exhaust from this product contains chemicals known to cause cancer, birth defects or other
reproductive harm.
Small gasoline engines produce high concentrations of carbon monoxide (CO). Gasoline or
propane powered equipment should not be used in enclosed or partially enclosed areas.
Symptoms of CO poisoning include, headache, nausea, weakness, dizziness, visual problems
and loss of consciousness. If symptoms occur get into fresh air and seek medical attention
immediately.
Gasoline Models - Consult the Engine Manufacturer’s Owner’s Manual and follow the directions for starting
the engine and allow the engine to warm up.
Refer to the Engine/Motor Manufacturer’s Owner’s Manual for maintenance information specific to the
engine/motor used.

Related product manuals