Photoelectric Beam Detector
SASO-PB D
Installation Instructions
Please note : This sensor is designed to detect intrusion and to initiate an alarm,
it is not a burglar-preventing device. Maker is not responsible for damage, ,injury
or losses caused by accident, theft, natural disasters, abuse, misuse, abnormal usage,
faulty installation or improper maintenance.
1. Description
Response time
adjustment
Terminals
Good LED
Tamper
Wiring Hole
Power LED
Tamper
Alarm LED
Lens
Monitor jack
Vertical
Adjustment screw
View finder
Cover
Transmitter
Receiver Plate
2. Cautions on Installation
3. Installation
3-1. Wall mount
Avoid direct
contact of sun,
auto-mobile head-
lights etc. to
transmitter or
receiver
Do not install the
unit on unsteady
surfaces.
Do not install in a
site where beams
may be interrupted
by trees or plants.
Do not install in
places where
units may be
splashed
continuously by
dirty water or
direct sea spray.
① Remove cover from unit
and slide the mounting
plate to detach it.
② Break grommet on mounting plate
and pull wire through it. Secure
the plate with 4mm screws.
③ When exposed wired, break knock-
outs on the rear of unit, pull wire
through as the figure and attach it to
the mounting plate.
④ After wiring is completed,
adjust alignment, check
operation and attach cover.
3-2. Pole mount (Pole size : Φ38 ~ Φ44mm)
① Remove cover from unit and slide the mounting plate to detach it.
② Attach pole brackets to pole and secure to mounting plate with screws.
③ Attach sensor body.
④ Pull through wire.
⑤ Connect terminals.
⑥ After wiring is completed, adjust alignment, check operation and attach cover.
To Next Page
Need help?
General
