C. RESET
If you wish to change the mode of your Wireless Mini Router or access the Router’s
settings page, rst you must reset the Router to its factory default. The following
steps will guide you through this process.
1. With the Mini Router plugged into an outlet, locate the small “Reset” button on the
side of the Router. Using a paper clip or similar small point, press and hold the reset
button for approximately three seconds (using long counts: one one thousand, two
one thousand...etc).
2. Release the reset button, then immediately press and hold it again until the WPS
light on the Mini Router briey ashes (about eight to ten seconds).
3. Unplug the Mini Router from the outlet, wait ve seconds, then plug it back in.
Repeat the steps from Section A “Setup” of this guide to access the Wireless Mini
Router’s settings page.
If you have any other questions about the Wireless Mini Router or any other Satechi
products, please contact our support team:
Phone: 1 (858) 268 1800
Email: support@satechi.com
www.satechi.net
www.facebook.com/satechi
To Previous Page
Loading...