Satechi Wireless Mini Router

To Next Page

WIRELESS MINI ROUTER QUICK SETUP GUIDE

A. SETUP

Plug the Wireless Mini Router into the wall. After approximately one minute, the

WLAN light on the Mini Router will turn on — the Mini Router is now broadcasting a

wireless network called “Wireless-N.” In your computer or other internet-accessible

device, go to your wireless settings and connect to the “Wireless-N” network. To do

this, you may have to disconnect from your current network. If your computer asks

for a PIN or to “set up” your network, click “connect without setting up.”

Once connected to “Wireless-N,” in your internet browser navigate to the address

“192.168.10.253” If prompted to enter a username and password, enter “admin” in

both  elds. This will direct you to the Mini Router’s settings page.

Click “Wizard” in the left sidebar. You will be directed to the mode select menu. Once

you select a mode, you will be guided through the setup process for that mode. After

mode setup is complete, you will need to disconnect from the “Wireless-N” network

and reconnect to your existing or newly-created network before you can use the

internet. More information about the Wireless Mini Router’s modes can be found in

Section B “Modes” of this Quick Setup Guide.

Wireless-N

User: admin

Pass: admin

Need help?

Do you have a question about the Satechi Wireless Mini Router and is the answer not in the manual?

Summary

Setup

Connect to Wireless-N

Plug router into wall, connect device to "Wireless-N" network.

Access Router Settings

Navigate to 192.168.10.253 and log in with admin credentials.

Use Setup Wizard

Select desired mode via the wizard for guided setup.

Modes

Router Mode

Connects to modem, broadcasts a new wireless network with a chosen SSID.

Repeater Mode

Strengthens existing weak wireless signals to increase network range.

Access Point Mode

Converts wired connection to wireless, broadcasting a new SSID.

Bridge Mode

Similar to Repeater, rebroadcasts existing network with a new SSID.

Client Mode

Converts wireless connection to wired for devices lacking Wi-Fi capability.

Reset

Reset to Factory Defaults

Procedure to reset the router to its original factory settings.