Satel GFU27 - Modem Configuration Guide; Default Settings

GFU27 User Guide
Version 3.0
13
3
MODEM CONFIGURATION
3.1
Default settings
The radio modem is shipped with the following default settings (unless otherwise specifically
ordered):
DEFAULT VALUES OF THE ADJUSTABLE SETTINGS ( the user can change these settings
later on )
Setting
Default value
Range
Radio frequency
Operating TX frequency 438.000 MHz Range: 403-473 MHz
Operating RX frequency 438.000 MHz Range: 403-473 MHz
Reference Frequency 438.000 MHz Range: 403-473 MHz
Channel Spacing 25 kHz Range:12.5, 20 or 25 kHz
Radio settings
Tx Power 1000 mW Range: 100, 200, 500 or 1000 mW
Signal threshold -112 dBm 80-118 dBm
FCS OFF ON/OFF
Tx-Start Delay 0 ms 0-65535 ms
Radio Compatibility SATEL 3AS SATEL 3AS, Option1=PCC 4-FSK,
Option 2=PCC GMSK, 3=TrimTalk
*)
Addressing
RX Address OFF ON/OFF
TX Address OFF ON/OFF
RX addressing to RS port
OFF ON/OFF
TX address auto switch OFF ON/OFF
Serial port 1
Status ON ON
Interface LVTTL Fixed
Data speed
19200 bps 300, 600, 1200, 2400, 4800, 9600,
19200, 38400
Data bits
8 7, 8, 9
Parity bits
None None, Even, Odd
Stop bits
1 1, 2
Handshaking
Handshaking lines apply to the DATA-port.
CTS Clear to send Clear to send, TX buffer state
CD Data on channel RSSI- threshold, Data on channel,
Always ON
RTS Flow Control Ignored, Flow Control, Reception
Control