17
2) Use the ▲ or ▼ key to select the channel for which to set
the offset, and then press the ENTER key.
The ON or OFF setting display appears.
3) Use the ▲ or ▼ key to select "ON", and then press the
ENTER key to display the offset value setting.
4) Use the ▲ or ▼ key to change the offset value, and then press the ENTER key to confirm.
5) When the offset value is confirmed, the channel selection display is resumed. For setting other channels,
repeat the steps from 2) above.
6) Upon completion of setting, press and hold the ESC key
for at least two seconds to return to the measurement
mode. If the offset is successfully set, the OFFSET
character lights up in the display.
Clock setting
This is used to set the clock in the unit.
1) Select the clock setting, and then press the
[ENTER] key.
The clock display format setting display appears.
2) Use the [▲] or [▼] key to select the clock display format,
and then press the [ENTER] key.
: 12-hour display
: 24-hour display
3) Set the date and time in the order of year, month, date, hour and minute.
Use the ▲ or ▼ key to select the value, and then press the [ENTER] key to confirm.
For setting the year, use the lower two digits.
4) Upon completion of setting, press and hold the ESC key for at least two seconds to return to the
measurement mode.
To Next Page
Loading...