10
Input
Output
Controller mode
MPPT efficiency
No load loss
Over voltage protection
Anti reverse connection protection
Working temperature
Weight
Size
3.3 Solar Controller
After the connection of the whole system is correct, if the sunlight is sufficient, the LED light
will flash several times and then the tube will light up, the controller will start to work, the
tube will display the system parameters in a cycle, and the LED light will indicate green
normally.
Status indication, as shown in the table below:
3.3.1 Controller Technical Specifications
3.3.2 Controller operation and status indication
Solar (solar indicator light)
Bat (output indicator)
( )
Fuse 15A
Battery (output line)
Charge Display
3.3.3 Output indication
16V〜50V/25A(MAX)
54V/7.5A(MAX)
MPPT
≥99%
< 5mA
58V±1.5V
-25℃ - 65℃
0.8Kg
L115×W111×H43(mm)
When the positive and negative poles of the battery
are connected reversely, the fuse will blow. The user
needs to replace the 15A, φ 5 × 20 glass tube fuse.
Show contents
The first digit of tube
Show contents
state
red
green
b
c
d
Status description
Solar panel access
Battery charging
Battery voltage
Solar panel input voltage
Solar panel charging current
To Next Page
Loading...