6. Keep raising the jack until the spare tire stops
moving upward and is held firmly in place.
This lets you know that the secondary
latch has released and the spare tire is
balancing on the jack.
7. Lower the jack by turning the folding wrench
counterclockwise. Keep lowering the jack until
the spare tire slides off the jack.
8. Disconnect the folding wrench from the jack
and carefully remove the jack. Use one hand to
push against the spare tire while firmly pulling
the jack out from under the spare tire with the
other hand.
9. Tilt the retainer and slip it through the wheel
opening when the spare tire has been
completely lowered.
10. Turn the folding wrench clockwise to raise the
cable back up if the cable is hanging.
Have the hoist assembly inspected as soon as
you can. You will not be able to store a spare tire
using the hoist assembly until it has been repaired
or replaced.
458
To Next Page
Loading...
