To lower the rear seatback, pull up on the seatback
strap while folding the seatback down. This allows
access to the trunk.
To raise the rear seatback pull the seatback up and make
sure it latches. Push and pull on the seatback to be sure it
is locked in position. Make sure that the safety belts are
properly stowed over the seatback in all three positions.
{ CAUTION:
A safety belt that is improperly routed, not properly
attached, or twisted will not provide the protection
needed in a crash. The person wearing the belt
could be seriously injured. After raising the rear
seatback, always check to be sure that the safety
belts are properly routed and attached, and are
not twisted.
{ CAUTION:
If either seatback is not locked, it could move
forward in a sudden stop or crash. That could
cause injury to the person sitting there. Always
push and pull on the seatbacks to be sure they
are locked.
When the seat is not in use, it should be kept in the
upright locked position.
1-9
To Next Page
Loading...
