å
Carefully turn your unit over onto its front edges.
å
Make equal margins along three edges of the BACK (I).
Push on the bottom edge of the RIGHT END and UPRIGHT
if needed to make it "square".
å
NOTE: The BACK should be against the bottom surface of
the TOP.
å
Fasten the BACK (I) to your unit using the NAILS (KK).
Step 6
411615 www.sauder.com/servicesPage 10
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
Unfi nished surface
NAIL
(13 used in this step)
KK
I
Edge without holes
To Next Page
Loading...
