Step 1
Look for this icon. It means a
video assembly tip is available at
www.sauder.com/services/tips
å
Assemble your unit on a carpeted fl oor or on the empty
carton to avoid scratching your unit or the fl oor.
å
To begin assembly, push a SAUDER TWIST-LOCK®
FASTENER (7F) into the large holes in the OUTER ENDS (A).
å
Repeat this step for the ENDS (B3 and C3), UPRIGHTS (D2
and E2), BOTTOMS (G2), MODESTY PANEL (H2), and UPPER
BACK MOLDING (MM).
416513 www.sauder.com/servicesPage 8
A
A
(25 used)
Do not tighten the TWIST-LOCK® FASTENERS in this step.
7F
Scan this QR code or go to this address:
http://qr.sauder.com/?ID=1659
to watch a video on how to assemble your unit.
To Next Page
Loading...
