Table of Contents Assembly Tools Required
Part Identifi cation
Hardware Identifi cation
Assembly Steps
Français
Español
Safety
Warranty
Hammer
Not actual size
No. 2 Phillips Screwdriver
Tip Shown Actual Size
Electric Drill with 1/4" bit
2-3
3-4
5-36
37-40
41-44
45-46
47
A SMALL END (1)
B LARGE END (1)
C DOOR END (1)
D UPRIGHT (1)
E TOP (1)
F BOTTOM (1)
G DOOR SHELF (3)
H DOOR UPRIGHT (1)
I LARGE SHELF (1)
J SMALL SHELF (1)
K BACK (1)
L LARGE DOOR (1)
M SMALL DOOR (1)
N LARGE ADJUSTABLE SHELF (2)
O ADJUSTABLE DOOR SHELF (3)
P SMALL ADJUSTABLE SHELF (2)
Q FRONT SKIRT (1)
R SIDE SKIRT (2)
S TOP MOLDING (1)
411572 www.sauder.com/servicesPage 2
Tape Measure
å While not all parts are labeled, some of the parts will have a label or an inked letter on the edge
to help distinguish similar parts from each other. Use this part identifi cation to help identify similar parts.
Part Identifi cation
To Next Page