Sauder WHISKER - Page 15

å
Fasten two EXTENSION RAILS (1) to the ENDS (J and Z).
Use six 1/2" FLAT HEAD SCREWS (16).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into
the 1st hole shown in the diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to nd the other
holes that line up with the holes in the ENDS. Turn a
SCREW into each hole.
1/2" FLAT HEAD SCREW
(6 used in this step)
16
1
Open end
1
st
Z
J
1
st
1
st
Open end
Open end
1
1
429610whiskersupport.com Page 15
STEP 10