Planning, transport, installation
LASERTEC 40
Page 9
Corrosion prevention
To prevent corrosion on the workpiece and machine, the installation
location must be dry and free of aggressive vapours:
• No soldering, welding, painting, pickling or electroplating systems in
the same room.
Foundation
A suitable bearing plate approved by a structural engineer is required.
• The bearing plate must not have any expansion joints in the area
covered by the machine.
• Cracks, cable ducts or other interruptions are not allowed in the area
covered by the machine.
• Place the machine on a firm floor that will provide a stable base for
the machine.
• The machine must be level and remain so to ensure the accuracy of
the machine.
• The floor must not give so that the machine remains exactly aligned.
To Next Page
Loading...