Planning, transport, installation
LASERTEC 40
Page 8
Installation location
Customer information
It is imperative this information is checked prior to the delivery of the
machine, safeguarded and implemented.
The responsibility for the correct location of the machine lies with the
customer. The customer is entirely responsible for a suitable installation
location.
If problems should arise later due to failure to follow the information
provided, SAUER cannot be held responsible.
Ambient temperature
The room must be evenly heated and the temperature should fluctuate as
little as possible:
• Adequately shield the machine from direct radiation from radiators,
the sun or neighbouring machines.
Wear reduction
To reduce wear, there must not be any machines in the same room that
may produce dust during machining.
• Also prevent dust from grinding or erosion entering the machine on
workpieces or in the cooling lubricant.
To Next Page
Loading...