Need help?Do you have a question about the Savillex DST-1000 and is the answer not in the manual?
General| Brand | Savillex |
|---|---|
| Model | DST-1000 |
| Category | Water Filtration Systems |
| Language | English |
DST-1000 is intended for purifying acids or water for sensitive analytical chemistry applications.
Savillex Corporation disclaims liability for errors, omissions, or inaccuracies in the manual.
Explains sub-boiling distillation process for producing high purity acid or water without bubbling.
Defines signal words like DANGER!, WARNING!, and symbols used for hazard communication.
Specifies that only qualified chemists should operate the unit with approved materials.
General safety advice for sub-boiling distillation, emphasizing care and compliance.
Covers fire, chemical burns, inhalation, eye irritation, and risks from system components.
Covers high voltage safety, grounding, and the procedure for system shut-off in emergencies.
Details electrical hazards, servicing precautions, and unit safety labeling.
Provides a diagram identifying key components of the DST-1000 acid purification system.
Describes the DST-1000's purpose, PFA construction, heating mechanism, and operation principle.
Lists technical specifications including power source, dimensions, materials, and operating parameters.
Provides instructions for unpacking, inspecting components, and handling damaged shipments.
Specifies operating environment requirements, including fume hood use and ambient conditions.
Details the step-by-step installation procedure for the DST-1000 unit and its components.
Illustrates filter vent assembly and provides instructions for filter membrane replacement.
Discusses suitable starting materials and outlines the initial cleaning procedure for the unit.
Provides cleaning guidelines for the collection bottle and transfer closure for ultratrace use.
Details standard operating procedures for setting up and preparing the DST-1000 for distillation.
Instructions on turning on the DST-1000, including settings and expected heating times.
Provides instructions on how to monitor and refill the reservoir during operation.
Steps for changing the type of acid used in the DST-1000 for distillation.
Explains the possibility of using a timer control unit for operating the still.
Provides guidance on safe overnight operation of the DST-1000, including setting selection.
Details routine cleaning and decontamination procedures for the DST-1000 unit's exterior and interior.
Provides a table of common faults, their possible causes, and corrective actions.
Discusses user-serviceable parts, warranty voiding, and availability of replacement parts.
Details the limited warranty terms, claims procedure, and limitation of liability.
Presents the electrical schematic diagram for the DST-1000 unit across different voltage configurations.
Manufacturer's declaration of conformity to relevant EC Directives and applied standards.
To Next Page
