SBM B6 SX - Maintenance

4
3. START-UP :
Manual operation
 Open the main gas valve.
 Switch the power on.
 Start the heater ignition cycle.
 If the flame is not lit after 45 seconds, start a second ignition cycle.
 If the flame is still not lit or goes out, close the main gas valve, switch
the power off and call your SBM installer.
Automatic control
(VisioLon Ind-T control module)
 Open the main gas valve.
 Switch the power on.
 Check the settings (temperature, time).
 Change module programming if necessary.
4. SHUT OFF :
 Close the main gas valve.
 Switch the power off.
5. MAINTENANCE :
 To be performed once a year by your SBM installer, according to the
SBM SX INSTALLER INSTRUCTIONS No. 05000048.
6. CHANGING THE GAS USED :
 For any change in the type of gas used, please contact your SBM
installer.