What to do if the SCA 2500KG Hydraulic Tools jack handle raises by itself when under load?
If the SCA Tools jack handle raises by itself when under load, ensure that the handle has been turned clockwise until it is firm and tight.
What to do if SCA Tools jack will lift load, but will not hold?
If your SCA Tools jack will lift a load but will not hold it, it may be due to air in the hydraulic system. You should release the air from the system.
Why SCA Tools jack will not lift to full height?
If the SCA Tools jack will not lift to its full height, it may be because there is air in the hydraulic system. You should release the air from the system.
How to fix SCA 2500KG Hydraulic Tools jack that will not lift load?
If the SCA Tools jack will not lift a load, ensure that the handle has been turned clockwise to a point at which it is firm/tight.
Why does my SCA Tools jack have poor lifting and a spongy pump?
If you're experiencing poor lifting performance or a spongy pump feel with your SCA Tools jack, it could be due to a couple of reasons: 1. The oil reservoir might be over-filled, in which case you should drain out some oil. 2. It may be necessary to lubricate all pivoting and moving parts.
What to do if SCA Tools jack will not lower completely?
If the SCA Tools jack will not lower completely, it may be due to a low oil level. Add oil as required.
Step-by-step guide to assemble the trolley jack handle for immediate use.
Pre-use checks and annual inspection recommendations for the trolley jack.
Instructions for purging air from the hydraulic system before operation.
Detailed steps on how to safely lift a vehicle using the trolley jack.
Instructions on how to safely lower a vehicle supported by the trolley jack.
Specifies the correct type of hydraulic fluid to use in the jack.
Guide on how to check and add hydraulic oil to the jack.
To Next Page
General