■ All of the nodes that were previously IP’d should be
listed on the screen; only a single node will be listed
when installing a single node system.
■ If any nodes are missing DO NOT proceed with
initialization.
■ Type ctrl+c and then enter no to the prompt.
This should return you to the command prompt
without initializing the system.
■ Working from the first node down, run the
sudo scnodeinit command again on all nodes
and ensure it completes successfully before
attempting system initialization once more.
■ If all nodes are shown in the list hit ctrl+c to proceed
with system initialization.
■ Type yes to confirm the initialization.
■ The nodes will now be initialized as a single HC3
system. This process typically takes 15-20 minutes.
Once it is complete the HC3 web interface will be
available in a web browser through the LAN IP of any
node in the system.
○ Additional Resources
■ Videos
■ HC3 Features Playlist
■ HC3 “How To” Playlist
■ Technical Help Papers
■ Networking Guidelines and Recommendations
■ Information Security with HC3
To Next Page
Loading...
